Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Fireplace Repair Across Woodland Hills
Fireplace repair in Woodland Hills usually comes down to one question: what’s actually wrong inside the flue? The homes here are older than most people realize, and a lot of them are still running on flues built before modern venting codes existed. We work with homeowners across Woodland Hills to sort out cracked firebox mortar, dampers that won’t seal, and chimney caps the Santa Ana winds have knocked loose, and we don’t recommend a thing until a camera shows us the reason. Call (855) 531-2802. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What sets our fireplace repair work apart is the order we do it in. Inspect first, recommend second. That matters more in Woodland Hills than in most places, because the housing stock here is a mix of mid-century ranches with original brick fireplaces and later rebuilds with factory-built metal fireplaces and gas inserts. Two houses on the same block can need completely different repairs.
Why Woodland Hills Homeowners Call Chimney Sweep Pacific Palisades for Fireplace Repair
Woodland Hills sits in the hot west San Fernando Valley, and that shapes the work. Summer highs that routinely climb into the 100s bake the exterior chimney stacks and dry out mortar crowns, while winter cold snaps drive real, steady wood burning. Creosote builds up fast when you’re burning seasoned hardwood against the cold, and Santa Ana wind events pull soot and creosote odor straight back into living rooms. Our technicians have up to 11 years of experience with exactly this cycle.
We handle the full chimney system, not just the visible parts: sweep, liner, crown, cap, firebox, damper. That means the person who diagnoses your fireplace problem can also do the firebox mortar work, fit a new top-sealing damper, or install a DuraFlex flexible liner if the camera shows the flue needs one. No referrals out, no scope gaps. We also use HeatShield ceramic flue resurfacing, which lets us repair certain liners without a full replacement when conditions allow.
Homeowners in Woodland Hills have a reasonable fear: being told they need thousands of dollars of liner or masonry work they have no way to verify. We answer that directly. Nothing gets recommended without camera evidence you can look at yourself, and we tell you plainly when a repair can safely wait until next season.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Fireplace Repair Services in Woodland Hills
We cover the six repairs that come up most in Woodland Hills homes. Each one starts with a diagnostic look, not a sales pitch.
Wood Burning Fireplace Repair
This is the big one for the 1950s-60s ranch homes along the south-of-101 canyon edges. Decades of heat cycling leave the firebox mortar cracked and the firebox brick spalling, and that’s where smoke leaks and carbon monoxide risk begin. We rebuild firebox mortar properly, not cosmetically, so the repair lasts through another Valley summer.

Damper Repair
A damper that won’t seal wastes heat up the flue all winter and lets hot Valley air down the chimney all summer. After Santa Ana winds, we routinely find top-sealing dampers that took damage and now leak air or blow ash back into the room. We repair or replace the damper assembly and check the seal before we call the job done.

Firebox Repair
Cracked firebox mortar is the most common structural issue we find in Woodland Hills masonry fireplaces. The heat cycling is relentless here: hot fires in January, then 100°F+ exterior heat in July drying out every joint. We assess the firebox with a camera and repair the mortar joints where the evidence shows real failure, not everywhere a salesperson points.

Fireplace Insert Service
Many Woodland Hills homes have had a gas insert or a factory-built fireplace added during a 1980s-2000s rebuild. Those need their own flue maintenance and their own inspection, and the venting has to match the appliance. When a homeowner changes an insert, we re-evaluate the whole flue system rather than swapping parts and hoping.
Trusted Brands We Service in Woodland Hills
We work with professional-tier chimney components: DuraFlex flexible liner systems for relining aging flues, HeatShield ceramic resurfacing for flue repair without full replacement where conditions allow, and Copperfield and Famco components for venting and caps. These are materials certified chimney professionals use, not the hardware-store substitutes that fail early. We don’t claim to stock parts, but we source the right component for your flue and turn the job around without a drawn-out wait. Built to last, not patched to pass.
See the difference
Before
After
Before
After
Before
AfterCommon Fireplace Repair Problems We See in Woodland Hills Homes
- Cracked firebox mortar in 1960s ranch fireplaces. Decades of heat cycling open the joints between firebox bricks, and that’s where smoke leaks and carbon monoxide risk start. It’s fixable, but only with real mortar work, not a smear of caulk.
- Spalling brick and dried-out chimney crowns on exterior stacks. The west Valley heat bakes exposed crowns until they crack, and water gets in through the failure and worsens the flue damage underneath. A crown that looks fine from the ground often isn’t.
- Damaged chimney caps and top-sealing dampers after Santa Ana winds. When a cap or damper takes a hit, downdrafts blow ash and creosote odor into living rooms. It’s often the first thing a homeowner notices and the easiest thing to verify.
- Unlined or clay-tile flues that never got updated. Many of these homes were built before modern venting codes, so any insert or appliance change means the entire flue system needs re-evaluating, not just a part swap.
Pricing for Fireplace Repair in Woodland Hills, CA
Fireplace repair here is priced per job by a written estimate, and the estimate is free. Typical ranges for Woodland Hills: a damper repair runs about $150-$400, firebox mortar repair about $400-$1,200, a chimney crown rebuild about $350-$900, and a DuraFlex liner install $2,500-$5,500 depending on flue length and condition. A HeatShield resurfacing job often lands between those last two when it’s an option. What moves the price is flue access, how much masonry is actually failing, and whether the camera shows one problem or several. You get the written estimate before anything is booked, and the number on it is the number you pay.
We Also Serve Cities Near Woodland Hills
We work across the west Valley and the canyons around Woodland Hills, including Tarzana, Topanga, Encino, and Sherman Oaks. The same mid-century housing stock and the same heat-and-wind cycle show up throughout, so the diagnostic approach carries over. If you’re just outside these lines, call and we’ll tell you straight whether we cover your street.
Serving Woodland Hills, CA – Our Local Coverage Area
We serve Woodland Hills and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Fireplace Repair in Woodland Hills
Not safely, in most cases. A 1960s clay-tile flue was sized and built for wood, and a gas insert changes the venting requirements, so the flue has to be evaluated first. In these south-of-101 ranch homes we typically find mortar joints eroded from decades of heat cycling, which means relining or a HeatShield resurfacing is often the right call before any insert goes in. We check it with a camera and show you the footage. Call (855) 531-2802 for an exact quote; estimates are free.
Downdrafts. Santa Ana winds push air down the flue, and if the chimney cap or top-sealing damper took damage, that air carries ash and creosote odor straight into the living room. It’s one of the most common calls we get in Woodland Hills after a wind event, and it usually points to a cap or damper repair rather than anything structural. A camera check confirms it. Call us to book a diagnostic visit.
First-degree creosote is a light soot you can sweep away; third-degree is a hard, glazed, tar-like layer that fuels chimney fires and needs professional removal. Woodland Hills homeowners burn seasoned hardwood through cold snaps, which builds creosote quickly, and a hot fire in a glazed flue is exactly the risk. We tell you which stage you’re at from what we pull out and see on camera. Call (855) 531-2802 for an exact quote.
In most cases it can be repaired. A damper that won’t seal is usually a warped blade, a rusted hinge, or a top-sealing damper that took wind damage, and none of those require rebuilding the fireplace. We repair or replace the damper assembly and verify the seal. Only if the camera shows failed firebox structure behind it would a rebuild come into the conversation, and we show you that evidence. Call us for a free estimate.
Yes. NFPA 211 calls for an annual inspection of the chimney and venting system regardless of how often you burn. In Woodland Hills that matters because summer heat dries out crowns and mortar even in a year you barely use the fireplace, so problems build quietly. An inspection is a standalone diagnostic here, not an upsell tacked onto a sweep. Book one whenever you’re ready.
Have a fireplace problem you can’t quite pin down? Call (855) 531-2802 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’ll show you what the camera sees before we recommend a thing.
Written by the team at Chimney Sweep Pacific Palisades.